Solutions Cubed Technical Support Forum: problem with 300cpr encoder - Solutions Cubed Technical Support Forum

Page 1 of 1

You cannot start a new topic
You cannot reply to this topic

problem with 300cpr encoder

#1 uday

Starting Member

Group: Members
Posts: 2
Joined: 05-July 05
Location:USA

Posted 05 July 2005 - 05:48 AM

Hi - I recently purchased the ENC300 for use with EZR robot wheel kit and the Motion Mind controller. While the controller and the motor seem to work fine, when I look at the encoder output on a scope, all I see is a flat 2V signal on one channel and 0V on the other, regardless of the motor speed. Could it be a broken encoder?
- Uday

#2 Lon

Advanced Member

Group: Root Admin
Posts: 640
Joined: 03-March 04

Posted 06 July 2005 - 07:43 AM

Could be. You can send it back for a replacement. You might want to take the cover off and verify that it's assembled correctly. Other than that the best I can do is replace the unit for you.

If you want to return it, send it back to...

Solutions Cubed, LLC
256 East First Street
Chico, CA 95928

Please include a note describing the problem you ran into, and provide your return address and phone number.

Lon